UV Direct to Film is a sticker alternative that thrives in all environments. Here are the simple steps to apply.
What You Will Need;
- Scraper
- Isopropyl Alcohol Spray (optional)
- Microfiber Towel (optional)
Step 1: UV DTF print and send will arrive to you rolled, the initial step is too cut and trim the desired print or design out.
Step 2: We recommend using isopropyl alcohol spray and a microfiber towel to ensure a clean, dust and debris free area prior to applying the design.
Step 3: Remove the clear laminate layer from the white backing paper, the print should stick to the top laminate layer. If it does not, try pulling an edge of the print with the laminate film.
Step 4: Begin adhering the sticker from one corner. Using the scraper or a thumb slowing make your way across the sticker sliding from left to right, removing any air bubbles as you go.
Step 5: Using a scraper or your thumb rub over the top of the laminate layer, strongly press the edges down to ensure strong adherence.
Step 6: Remove the top laminate layer from the blank, the best method to remove is slowly with the laminate layer peeling back onto itself. If any fine lines or sections of the sticker are lifted during this process you can attempt to reattach it to the blank.
Follow these simple steps to apply your UV DTF transfers to everything!!!!
Want some more information about UV DTF transfers click here.